'RAM Booting' menu
'Flash ROM' menu
Please check the below.
C2000
STM32
AM263x
TM4C
MSPM0
PSoC4
XMC1
XMC4
RA
RX
TX, TXZ3
LPC
'Reload *.out' menu
reloads output file (*.out, *.elf or *.axf). It comes in handy when you use debugger and easyDSP together or when you uses easyDSP only for communication (not using /RESET and BOOT pin).
For the MCU easyDSP doesn't support flash programming such as XMC1, please use this menu to update symbol information whenever the user program is updated (programmed).
'Reset MCU' menu
The /RESET pin of easyDSP pod goes down to low for 500ms to make reset MCU.
The /BOOT and BOOT pin of easyDSP pod are inactive : no signal output from them.
For the MCU easyDSP doesn't support flash programming such as XMC1, this menu is not disabled.
'Reset Communication' menu
It initializes the states of ISR for easyDSP.
'Pause(Resume) Communication' menu
It pauses the communication of easyDSP. This menu toggles into 'Resume Communication' menu.
'Communication Status' menu
It displays the target MCU of easyDSP pod and communication state such as read/write fail/success ratio. Over 90% of success ratio is mandatory to have fluent communication.
