Please connect
easyDSP header RX
and TX pin to the selected UART pins of MCU.
Also connect easyDSP header #4 pin to
VDDD.
RX and TX pins of easyDSP
header are pulled up with
100kOhm resistor in the pod.
- In case there is a reset IC between easyDSP
/RESET and MCU XRES, it should transfer easyDSP /RESET signal to MCU XRES
within 0.5sec.
- In case pullup resistor is attached, resistor value should be higher than several k Ohm.