To do monitoring and flash
programming together, SCI1 should be connected to easyDSP.
So connect RXD1 and TXD1 pins of MCU to the easyDSP RX and TX
pins.
Also
connect easyDSP header #4 pin to MCU VCC.
Please check the corresponding pins by MCU
type in the table below. The number of pin should be checked from
MCU datasheet.
In case MCU has UB or UB# pin, it
should be pulled down or pulled up respectively.
Other
considerations :
- When reset, easyDSP /RESET pin
goes low for 500msec around.
- In case there is a reset IC
between easyDSP /RESET and MCU RES#, it should transfer easyDSP /RESET signal
to MCU RES# within 0.5sec.
-
RX and TX pins of easyDSP
header are pulled up with 100kOhm resistor in the pod.
- In case you can't use SCI1, you can use another SCI channel
but only monitoring is doable (flash programming not doable). In
this case no need to connect /BOOT and /RESET pins.